HP 250C - Manual (Page 97)

6Ć39 Removal and Replacement C4699Ć90000
10 Slide the carriage to the right, and
remove it with the belt from the plotter.
Reassembling: Positionthe belt under the
back extrusionof the carriage.
Make sure that you correctly reconnect the
trailing cable ' page 6Ć35.
After reassembling, make sure that you check
the carriageĆtoĆmedia distance ' page 7Ć11.
Calibration: After having reassembled the
plotter, perform the black cartridgeĆalignment.
(Details ' User's Guide.)
Removing the Drive Belt
1 Remove the cartridge carriage ' page 6Ć37.
2 Release the belt from the clips on the
underside of the carriage.
Reassembling: Clip the belt to the carriage,
using the same part of the belt as was
originally used. Also, match the vertical lines
onthe belt with the vertical grooves onthe
carriage. The horizontal lines on the belt face
outwards.