HP 250C - Manual (Page 95)

6Ć37 Removal and Replacement C4699Ć90000
Removing the Cartridge
Carriage
1 Remove the encoder strip ' page 6Ć17.
2 Remove the right bracket ' 6Ć21.
C A U T I O N
In the following step, take care not to break
the black plastic tab on top of the motor.
3 Pressthe carriage motor towardsthe left,
and remove the belt from the motor shaft.
If you need greater maneuverability of the
motor, press the black plastic tab on top
very slightly downwards.
A
B
Reassembling: Make sure the belt is
correctly positioned on the grooves of the
shaft.
4 Rotate the motor on itshinge out towards
the back of the plotter.
5 Release the belt from the pulley on the
left of the plotter.
Reassembling: Make sure the belt is
correctly positioned on the grooves of the
pulley.
W A R N I N G
In the following steps, take
care neither to cut yourself
on the encoder strip, nor to
damage the strip.