HP 250C User Manual

Page 145

Error + Fast + Load Media:

Problems in movement in the XĆaxis (media axis)

The possible causes could be: D Something is causing too much friction in the

X-axis. D Paper jam.

Error + Load Media + Normal:

Error in XĆaxis calibration

Did you load media in correct orientation? D Are the marks visible on the

plot? If not, check cartridges. D Are cartridges correctly aligned? If so, the

problem may be in the electronics module, media motor or driveĆroller gear;

if alignment is incorrect, the problem may be in the carriage. There could

also be a problem with the line sensor.

Paper + Cartridges + Error + Normal:

Electrical error

The possible causes could be: D Missing or badly seated cartridge. D One

end of the trailing cable is not connected or is badly connected, or the trailing

cable is faulty. D Faulty fan, or fan is disconnected. D Faulty carriage PCA.

D Faulty electronics module.

For more precise troubleshooting ' page 8Ć19, w System Errors.

Steady 368

Steady 356

Steady 1238

Paper + Error + Film + Fast:

Not enough memory for the sensor data

structure.
D Turn the plotter off, and then on again to see if the problem disappears.

D If the problem remains, consult recent service notes for a possible solution.

D If no service note deals with this error, report the problem to your HP

Response Center. Note conditions and actions before error occurred. Include

setup sheet and service configuration plot in report.

Steady 1345

Paper + Cartridges + Error + Film:

Communication broken between the two

processors on the main PCA.
Replace the electronics module.

Steady 1234

Paper + Error + Film + Load Media:

Problems in the free movement of the

carriage.
The possible causes could be: D Something is causing excessive friction in the

YĆaxis (carriage axis). D The carriage touches the bail as it moves.