HP 250C - Manual (Page 152)

Plain + Error + Film + Fast + Roll:
CartridgeĆalignment firmware error. Try
one or more of the following:
D Turn the plotter off, andthen on again to see if the problem disappears.
D Ensure that the cartridges are correctly seated. D Replace cartridges.
D If the problem remains, consult recent service notes for a possible solution.
D If no service note deals with this error, report the problem to your HP
Response Center. Note conditions and actions before error occurred. Include
setup sheet andservice configuration plot in report.
Plain + Load Media + Error + Film + Fast:
Error in bailĆlift mechanism. The
bailĆlift system is unable to raise or lower the bail. (It is the carriage that
tests to see whether the bail is in the correct position by trying to knock
against it.)
D Check the bailĆlift system to see if it is working correctly D Use the bail
cycle test to help troubleshoot.
For more precise troubleshooting ' page 8Ć23, w System Errors.
Load Media + Error + Film + Fast :
Error in YĆaxis encoder quadrature
(Carriage axis). Possible causes are:
D Broken or damaged encoder strip.
D Incorrect routing of the motor cables.
D Electrical noise in motors. D Faulty motor encoder. D Motor receivedan
electrostatic discharge while operating.
Steady 13459
Steady 12345
Steady 2345
Plain + Error + Normal + Roll:
Firmware failure (generic).
D Turn the plotter off, andthen on again to see if the problem disappears.
D If the problem remains, consult recent service notes for a possible solution.
D If no service note deals with this error, report the problem to your
HP Response Center. Note conditions and actions before error occurred.
Include setup sheet and service configuration plot in report.
For more precise troubleshooting ' page 8Ć23, w System Errors.
Steady 1389
8Ć18 Troubleshooting C4699Ć90000