HP 250C - Manual (Page 91)

6Ć33 Removal and Replacement C4699Ć90000
Removing the Back Cover
1 Remove the left and right endĆcovers
' pages6Ć9 and 6Ć10.
2 Remove the screws that attach the back
cover to the plotter.
D/A1Ćsize plotters have 2 screws.
E/A0Ćsize plotters have 3 screws.
Torx-20
Reassembling: Before replacing the
screws, ensure that the electronics module
is flush against the inside back of the
plotter.
C A U T I O N
In the following steps, take care not to
damage the parallelĆport clips.
3 Pull the bottom of the cover slightly back
and out from the plotter.
4 Lift the cover up, and remove it from the
plotter.