HP PN1050 User Manual
Page 73
ENWW
Using the Embedded Web Server 73
CAUTION
You should ensure secure embedded Web communications
through HTTPS is enabled before creating the initial SNMP
v3 account. This will help to prevent access or interception
of account information over a connection that is not secure.
SNMP v1 and v2c agents can coexist with the SNMP v3
agent. However, to fully secure SNMP access, you should
disable SNMP v1 and v2c.
Other
Use this tab to enable or disable various protocols supported by the projector
server for services and management. See
Table 4.8
Other Protocols
Item
Description
Enable Device
Discovery
Enable or disable device discovery protocols supported by
the projector server:
SLP (Service Location Protocol).
If enabled (checked), the server sends SLP packets,
which are used by system applications for automated
discovery and installation.
If disabled (cleared), SLP packets are not sent.
Multicast IPv4.
If enabled (checked), the server will send and receive
IP version 4 multicast packets.
Enable Management
Protocols
Enable or disable the use of FTP to upgrade firmware on
the server. FTP is not a secure protocol, and device
passwords may be intercepted.
Disabling FTP firmware upgrades is recommended.