HP PN1050 - Manual (Page 31)

ENWW TCP/IP Configuration 31
Other Settings
link-type:
(10/100 Fast Ethernet) Sets the projector server’s link speed (10 or 100 Mbps) and
communication mode (Full- or Half-Duplex). Selections are AUTO, 100FULL,
100HALF, 10FULL, 10HALF.
For AUTO (default), the server uses autonegotiation to determine the link speed
and mode. If autonegotiation fails, then 100HALF is set.
upgrade:
To configure one or more Jetdirect projector servers with the name and location
of a firmware upgrade file.
CAUTION: Ensure that command parameters are properly entered and that the
upgrade file is a higher version than the currently installed version. The server will
attempt to upgrade when the upgrade file contains a higher version than the
installed version.
The command format is:
upgrade:
where,
TFTP Server IP is the IP address of the TFTP server,
Version specifies the firmware version of the upgrade file,
Product Number specifies and must match the product number of the server,
Filename is the path and filename of the firmware upgrade file.
Support
support-name:
(support-contact:)
Typically used to identify the name of a person to contact for support of this device.
support-number:
Typically used to specify a phone number or extension to call for support of this
device.
support-url:
A Web URL for product information on this device over the Internet or an intranet.
tech-support-url:
A Web URL for technical support over the Internet or an intranet.
Table 3.3 TFTP Configuration File Parameters (7 of 7)