HP PN1050 - Manual (Page 56)

ENWW Using the Embedded Web Server 56
SNMP
You can specify or change the SNMP (Simple Network Management
Protocol) parameters provided. See
Table 4.4 .
CAUTION If you use HP Web Jetadmin to manage your devices, you
should use HP Web Jetadmin to seamlessly configure
SNMP v3 and other security settings on the projector server.
Using the embedded Web server to create the SNMP v3
account will erase any existing SNMP v3 accounts. In
addition, the SNMP v3 account information will need to be
implemented on the SNMP management application. For
more information, see “
SNMP v3 .”
Table 4.4 SNMP Settings (1 of 2)
Item Description
Enable SNMPv1/v2
read-write access This option enables the SNMP v1/v2c agents on the
projector server. Custom community names can be
configured to control management access to the server.
An SNMP Set Community Name is a password to be able
to configure (or “write”) SNMP information on the
HP Jetdirect projector server.
An SNMP Get Community Name is a password to retrieve
(or “read”) SNMP information on the HP Jetdirect projector
server.
An incoming SNMP SetRequest or GetRequest command
must contain the appropriate Set or Get community name
before the server will respond.
A community name must be ASCII characters and can be
up to 255 characters long.
The default Get community name is “public”, which can be
disabled to restrict access by checking the checkbox
provided.
Note: If “public” is disabled, some discovery utilities
may not operate properly.
Enable SNMPv1/v2
read-only access This option enables the SNMP v1/v2c agents on the
projector server, but limits access to read-only.
Write-access is disabled. The default Get community name
“public” is automatically enabled.