HP PN1050 User Manual
Page 37
ENWW
TCP/IP Configuration 37
6.
Enter the range of IP addresses for this scope (beginning IP address and
ending IP address). Also, enter the subnet mask. then click Next.
Note
If subnetting is used, the subnet mask defines which portion
of an IP address specifies the subnet and which portion
specifies the client device. For more information, see
.
7.
If applicable, enter the range of IP addresses within the scope to be
excluded by the server. Then click Next.
8.
Set the IP address lease duration for your DHCP clients. Then click Next.
HP recommends that all projectors be assigned reserved IP addresses.
This can be accomplished after you set up the scope (see step
9.
Select No to configure DHCP options for this scope later. Then click Next.
To configure DHCP options now, select Yes and click Next.
a.
If desired, specify the IP address of the router (or default gateway)
to be used by clients. Then click Next.
b.
If desired, specify the Domain Name and DNS (Domain Name
System) servers for clients. Click Next.
c.
If desired, specify WINS server names and IP addresses. Click Next.
d.
Select Yes to activate the DHCP options now, and click Next.
10. You have successfully set up the DHCP scope on this server. Click Finish
to close the wizard.