Table 3.1 – HP PN1050 User Manual
Page 20
ENWW
TCP/IP Configuration 20
Table 3.1
Tags Supported in a BOOTP/DHCP Boot file (1 of 3)
Item
RFC
2132
Option
Description
nodename
--
The name of the peripheral. This name identifies an entry
point to a list of parameters for a specific peripheral.
nodename must be the first field in an entry. (In the
example above, nodename is “picasso”.)
ht
--
The hardware type tag. For the HP Jetdirect projector
server, set this to ether (for Ethernet). This tag must
precede the ha tag.
vm
--
The BOOTP report format tag (required). Set this
parameter to rfc1048.
ha
--
The hardware address tag. The hardware (MAC) address
is the link-level, or station address of the HP Jetdirect
projector server. It is printed on a label attached to the
server, and displayed by the embedded web server.
ip
--
The IP address tag (required). This address will be the
HP Jetdirect projector server’s IP address.
sm
1
The subnet mask tag. The subnet mask will be used by
the HP Jetdirect projector server to identify the portions of
an IP address that specify the network/subnetwork
number and the host address.
gw
3
The gateway IP address tag. This address identifies the
IP address of the default gateway (router) that the
HP Jetdirect projector server will use for communications
with other subnets.
ds
6
DNS (Domain Name System) server’s IP address tag.
Only a single name server can be specified.
lg
7
The syslog server’s IP address tag. It specifies the server
that the HP Jetdirect projector server sends syslog
messages to. For more information, see
.