HP PN1050 - Manual (Page 29)

ENWW TCP/IP Configuration 29
default-ip:
Specifies the IP address to use when the projector server is unable to obtain an
IP address from the network during a forced TCP/IP reconfiguration (for example,
when powered off/on or manually configured to use BOOTP/DHCP).
DEFAULT_IP: sets the legacy default IP address 192.0.0.192.
AUTO_IP: sets a link-local IP address 169.254.x.x.
The initial setting is determined by the IP address obtained when first powered on.
default-ip-dhcp:
Specifies whether DHCP requests will be periodically transmitted when a legacy
default IP address 192.0.0.192 or link-local IP address 169.254.x.x has been
automatically assigned.
0: Disables DHCP requests.
1 (default): Enables DHCP requests.
dhcp-arbitration:
Specifies the amount of time, in seconds, that the projector server will wait for
DHCP configuration offers. A value from 1 to 10 may be set. The default is 5
seconds.
phone-home-config:
Specifies privacy settings on the projector server during embedded Web server
access. This command controls whether statistical data on product use may be
sent to HP. For HP to collect data, Internet access is required.
2: Prompt the user to allow sending data on initial access to the Networking tab of
the embedded Web server. This is the factory-default and cold-reset value. Once
changed, this value cannot be re-selected.
1: Allows the sending of data to HP without prompting the user.
0: Disables sending data to HP without prompting the user.
web-refresh:
Specifies the time interval (1 – 99999 seconds) for embedded Web server
diagnostic page updates. If set to 0, the refresh rate is disabled.
Table 3.3 TFTP Configuration File Parameters (5 of 7)