HP PN1050 - Manual (Page 58)

ENWW Using the Embedded Web Server 58
Misc. Settings
The Miscellaneous Settings parameters allow you to set a variety of advanced
protocols and features, as described below. See
Table 4.5 .
Table 4.5 Miscellaneous Settings (1 of 2)
Item Description
SLP Config Enable or disable SLP (Service Location Protocol), used by
selected client application software to automatically discover and
identify the HP Jetdirect projector server.
Multicast IPv4 Enable or disable the receipt and transmission of IP version 4
multicast packets by the projector server.
NOTE: If this parameter is disabled, other protocols that use
multicast protocols, such as SLP, may also be disabled
without notification.
Link settings (For wired 10/100TX networks only) Set the network link
speed(10 or 100 Mbps) and communication mode (full- or
half-duplex) for HP Jetdirect projector servers. The available
settings are listed below.
CAUTION: If you change the link setting, network
communications with the server and network device may be
lost.
● AUTO: (Default) The server uses autonegotiation to match
the network’s link speed and communication mode. If
autonegotiation fails, 100TXHALF is set.
● 10TXFULL: 10 Mbps, full-duplex operation
● 10TXHALF: 10 Mbps, half-duplex operation
● 100TXFULL: 100 Mbps, full-duplex operation
● 100TXHALF: 100 Mbps, half-duplex operation
Primary DNS
Server Specify the IP address of the primary DNS (Domain Name
System) server.
Secondary DNS
Server Specify the IP address of a secondary DNS server to use if the
primary DNS server is unavailable.
Locally
Administered
Address Specifies a locally administered address (LAA) that replaces the
factory-assigned LAN Hardware (MAC) address. If LAA is used,
a user-specified string of exactly 12 hexadecimal digits must be
entered.
The LAA address must start with hexadecimal X2, X6, XA, or XE,
where X is any hexadecimal digit 0 through F.
The default address is the factory assigned address.