HP PN1050 User Manual
Page 61
ENWW
Using the Embedded Web Server 61
Wizard
Note
If you use HP Web Jetadmin to manage your devices, you
should not use this wizard. Instead, use HP Web Jetadmin
to configure your network security settings to ensure they
are properly set for your network.
The Wizard page allows you to run the HP Jetdirect Security Configuration
Wizard. This wizard will guide you through the projector server’s security
configuration needed for your network. Click Start Wizard to run the wizard.
This opens the Security Level page.
The optional configuration parameters presented by the wizard will depend
on your choice of security level. For an overview, see
Note
If you improperly exit the wizard (for example, by failing
to use the Cancel button), an Operation Failed screen may
appear. If so, wait approximately two minutes before
entering the wizard again.
Restore Defaults
This page is used to restore security configuration settings to factory defaults.
The default settings displayed depend on the features supported by the
projector server.
Only the security settings listed are restored to factory defaults, other
configuration settings are not affected.