HP PN1050 - Manual (Page 44)

ENWW TCP/IP Configuration 44
Using the Embedded Web Server
You can set IP parameters on HP Jetdirect projector servers that support the
embedded Web server. For more information, refer to
Chapter 4 .
Moving to Another Network
When moving an HP Jetdirect projector server that is configured with an IP
address to a new network, make sure that the IP address does not conflict with
addresses on the new network. You may change the IP address of the server
to one that can be used on the new network, or erase the current IP address
and configure another address after it is installed on the new network. See
Chapter 6 , “ Troubleshooting the HP Jetdirect Projector Server ,” for
instructions to reset the server to factory default settings.
If the current BOOTP server is not reachable, you may need to locate a
different BOOTP server and configure the projector to this server.
If the server was configured using BOOTP, DHCP or RARP, edit the
appropriate system files with updated settings. If the IP address was manually
set, reconfigure IP parameters as described in this chapter.