HP A9834-9001B - Manual (Page 87)

Chapter 3
Installing the System
Unpacking and Inspecting the System
87
WARNING Do not remove the bolts on the mounting brackets that attach to the pallet.
These bolts prevent the cabinet from rolling off the back of the pallet.
Step 3. On the other side of the pallet, remove only the bolt on each mounting bracket that is attached to
the cabinet.
Step 4. Insert the ramps into the slots on the pallet.
CAUTION Make sure the ramps are parallel and aligned (Figure 3-10).
The casters on the cabinet should roll unobstructed onto the ramp.
Figure 3-10 Positioning the Ramps
WARNING Do not attempt to roll a cabinet without help. The cabinet can weigh as
much as 1400 lb (635 kg). Three people are required to roll the cabinet off
the pallet. Position one person at the rear of the cabinet and one person on
each side.
WARNING Do not attempt to move the cabinet, either packed or unpacked, up or down
an incline of more than 15
o .