Mp command: cc, Cc - complex configuration, Access level—administrator – HP A9834-9001B User Manual
Page 178: Scope—complex, Exampleb3 cc command
Appendix B
Management Processor Commands
MP Command: CC
178
MP Command: CC
CC - Complex Configuration
•
Access level—Administrator
•
Scope—Complex
This command performs an initial out of the box complex configuration. The system can be configured as
either a single (user specified) cell in partition 0 (the genesis complex profile) or the last profile can be
restored. The state of the complex prior to command execution has no bearing on the changes to the
configuration. The user is responsible for ensuring that all other partitions are shut down before using this
command. The use of the ID command could be required following the creation of the genesis complex profile.
If the genesis profile is selected, then all remaining cells will be assigned to the free cell list.
NOTE
This command does not boot any partitions. The user must boot the desired partition(s) using
the BO command.
NOTE
The best choice of cell to use in the genesis complex profile is one that has a bootable device
attached.
Example B-3
CC Command