HP A9834-9001B - Manual (Page 225)

Appendix C
Powering the System On and Off
Powering On the System Using the pe Command
225
Powering On the System Using the pe Command
This section describes how to power on the system. Use the following procedures whenever the system needs
to be powered on.
Step 1. From the Command Menu, enter the pe command.
IMPORTANT If the complex has an IOX cabinet, power on this cabinet first.
In a large complex, cabinets should be powered on in one of the two following orders:
• 9, 8, 1, 0
• 8, 9, 0, 1
Step 2. Enter B and then the cabinet number (Figure C-15).
Figure C-15 Power Entity Command
Step 3. The power state is OFF. Enter on to power on the cabinet.