Huawei DR814Q - Manual (Page 15)

User Manual
Aolynk DR814Q ADSL2+ Broadband Router
3 Getting Started
10
Note:
z To change the login password, refer to section 4.4.1 “Password” for detailed
information.
z If you receive an error message or the configuration page cannot be displayed, refer
to section 6.1 “DR814Q Troubleshooting” for detailed instructions.
3.3 Description of the Factory Default Settings
The DR814Q is configured with factory default settings for SOHO users.
The table below lists some of the most important default settings and the subsequent
chapters will cover all the features in detail. If you are familiar with network
configuration, review these settings to verify that they meet the requirements of your
network and follow the instructions to change them if necessary. If not, use the DR814Q
with the default settings.
Table 3-1 Description of the factory default settings
Item Default settings Description
Default user
name/password
Administrator:
admin/admin
Common user:
user/user
You can log into the Web configuration
page as an administrator or a common
user. Different operation rights are
available for different login users.
Refer to 4.4.1 “Password” for detailed
information.
IP address of the
LAN port
Assigned static IP
address:
192.168.1.1
Subnet mask:
255.255.255.0
This is the IP address of the DR814Q
LAN port which connects the DR814Q
to your Ethernet network. Generally,
there is no need to change this
address.
DHCP
(dynamic host
configuration
protocol)
DHCP server
enabled with the
following pool of
addresses:
192.168.1.2 to
192.168.1.51
The DR814Q provides a pool of
private IP addresses for dynamic
assignment to PCs in the LAN. To use
this service, you must configure your
PC to obtain an IP address
dynamically. Refer to section 7.2.1
“Specifying to Obtain an IP Address
Automatically”.
NAT (network
address translation)
NAT enabled
Your PC’s private IP address is
translated to the public IP address
whenever it accesses the Internet.
Refer to section 5.2.1 IV. “NAT
configuration” for detailed information.
DSL mode Multimode
Applicable to multiple standard DSL
line modes.