Huawei DR814Q - Manual (Page 108)

User Manual
Aolynk DR814Q ADSL2+ Broadband Router
11 Appendix - Glossary
103
omputer or router, through which data
P
to-point protocol. It is a communication protocol for data transmission between
P
t protocol over ATM. One of the two types of PPP interfaces. The other
P
o types of PPP interfaces. The other
type is PPPoA. You can specify multiple PPPoE interfaces for each VC.
Protocol
A set of rules to govern the data transmission. The two connected ends must obey
e rules to transmit data.
R
A geographically separated location. For example, an employee on travel who logs into
company’s intranet is a remote user.
R
standard connector used to connect telephones, fax machines, and Modems to a
R
8-pin connector used for transmitting data over the telephone lines.
R
arding data between the local network and the Internet through the most efficient
nodes from the host located in the center of the network, such as the server, work
Port
A physical access point on a device such as a c
flows into and out of the device.
PP
Point-
devices over the standard telephone line. The WAN port on the DR814Q uses two
types of the PPP, that is, PPPoA and PPPoE.
PPoA
Point-to-poin
type is PPPoE. You can specify only one PPPoA interface for each VC.
PPoE
Point-to-point protocol over Ethernet. One of the tw
thes
emote
the
J-11
The
telephone port. It is a 6-pin connector usually holding four wires.
J-45
The
Straight-through cables are usually the connector of this type.
outing
Forw
path, based on the data’s destination IP address and current network conditions. A
device that performs routing is called a router.
SNMP
Simple network management protocol (SNMP), a network management standard, is
widely used in the TCP/IP network. SNMP provides a way to manage the network