Enterasys Networks 700 - Manual (Page 87)

Managing the Module 2-67
The MultiSwitch 700 Device View
Enabling and Disabling VLANs
To enable or disable VLANs:
1. Select the desired VLAN entry in the Configured VLANS list box.
2. In the VLAN Admin field, click to select Enable or Disable.
3. Click the Apply button. The selected VLAN will be enabled or disabled,
depending on your selection.
Updating VLAN Config Window Information
Clicking the Refresh button will update the information displayed in the
Configured VLANs list without closing the window.
Performing Ingress List Configuration
802.1Q VLAN port assignment and ingress list configuration operations are
performed using the VLAN Port Config window, which is accessed from the
Device
menu in your switch’s Device View. See Ingress List Operation , on
page 2-62 for details on ingress lists. To launch the window:
1. Click on Device in the Device View menu bar to display the Device menu.
2. Click on 802.1Q VLAN and then right to select 802.1Q VLAN Port Config.
The VLAN Port Config window,
Figure 2-27 , opens.
NOTE
Unless Enable is selected when a VLAN is initially defined, it is disabled by default. A
new VLAN that is left in a Disabled state will remain disabled until a port is assigned to
it, at which time it will be automatically enabled. If you are changing a VLAN’s port
assignment, the VLAN should be disabled before changing the port configuration. See
Performing Ingress List Configuration , on page 2-67 , for details on completing your
VLAN port configuration.