Enterasys Networks 700 User Manual
Page 52
The MultiSwitch 700 Device View
2-32
Managing the Module
configured to operate in Full Duplex, effectively doubling the available wire
speed (from 10 to 20 Mbps in standard Ethernet mode, or from 100 to 200 Mbps in
Fast Ethernet mode); 100Base-FX (fiber) ports can be configured to operate in their
standard 100 Mbps mode, or in Full Duplex mode. This window also displays the
mode currently in effect on the selected interface, and provides some information
(where it is available) about the interface’s link partner.
To access the Port Configuration Window:
1.
Select the port you wish to configure; the Port Menu will display.
2.
Click Configuration. The Fast Ethernet Port Configuration window,
, opens.
Figure 2-16. The Fast Ethernet Port Configuration Window
NOTE
Auto-Negotiation is not supported by the DELFX-UI Fast Ethernet port interface
module. If you launch the window for a port module slot which has no port interface
module installed, the Port Type will display as Unknown, the Link State will display No
Link, and the rest of the fields will be blank and/or grayed out.