Setting the desired operational mode, Auto negotiation technologies – Enterasys Networks 700 User Manual
Page 60
The MultiSwitch 700 Device View
2-40
Managing the Module
Setting the Desired Operational Mode
For any 100Base-TX port, you can configure operational modes, or you can select
Auto Negotiate mode, which allows the port to negotiate with its link partner to
find the highest mutually available bandwidth and flow control. If you select
Auto Negotiate mode, you must also choose which of the port’s bandwidth and
flow control capabilities you wish to advertise to the link partner (refer to
page 2-40
).
100Base-FX ports do not support auto negotiation for bandwidth or flow control
capability, so you must choose between 100Base-FX Half Duplex and 100Base-FX
Full Duplex mode, and set the flow control option. However, you must still be
sure that both link partners are set to the same operational mode, or the link will
be unstable.
For 1000Base-SX/LX/CX ports the speed and duplex modes are always
configured at 1000MB Full Duplex. However, you can select Auto Negotiate
mode, which allows the port to negotiate with its link partner to find the highest
mutually available bandwidth and flow control. If you select Auto Negotiate
mode, you must also choose which of the port’s bandwidth and flow control
capabilities you wish to advertise to the link partner (refer to
).
To set your desired operational mode:
1.
Click on the Speed, Duplex, or Flow Control list box to display the menu of
available options; click to select the operational mode you wish to set.
2.
Click on the Apply button to save your changes.
Auto Negotiation Technologies
For ports which have been configured to operate in Auto Negotiate mode, this list
box allows you to select which of the operational modes available to the port will
be advertised to the negotiating link partner.
During Auto Negotiation, each of the link partners will advertise all selected
modes. Of the selected modes, the highest mode mutually available will
automatically be used. If there is no mode mutually advertised, no link will be
achieved.
NOTE
If the port you are configuring does not support Flow Control, the Current Mode field will
display “not supported” and the Desired Mode list box will be disabled.