Eicon Networks DIVA LAN ISDN - Manual (Page 191)

Appendix C: Command Line Reference Phone 191
Phone
ENABLE PHONE ALTRING channel
DISABLE PHONE ALTRING channel
Valid context: General
If you have two phone numbers assigned to phone port, the DIVA LAN ISDN Modem assigns a distinctive ring
to each number.
If you ENABLE PHONE ALTRING for a port, the assigned rings are swapped.
channel: PHONE port number. Range: 1 to 2.
ENABLE PHONE CALLBUMPING
DISABLE PHONE CALLBUMPING
Valid context: General
Enables or disables call bumping. Call bumping is only effective if you are using MLPPP, MLPPP+BACP, or
MLPPP+AO/DI. When enabled, an incoming or outgoing voice call will temporarily disconnect one channel of
an active data call. If PPP is in use on both B-channels, then call bumping does not work (incoming and
outgoing calls will receive a busy signal).
ENABLE PHONE CALLWAITING [port]
DISABLE PHONE CALLWAITING [port]
Valid context: General
Enables or disables call waiting for analog phones (POTS).
port: Phone port number. Range: 1 to 2. Default: applies to both ports.
ENABLE PHONE CALLS channel [IN | OUT]
DISABLE PHONE CALLS channel [IN | OUT]
Valid context: General
Enables or disables incoming and/or outgoing POTS phone calls on a specific ISDN channel.
channel: ISDN channel. Range: 1 to 2.
IN: Enable/Disable incoming calls.
OUT: Enable/Disable outgoing calls.
SET PHONE RING FREQUENCY {0 | 20 | 25 | 40 | 50}
Valid context: General
Specifies the ringer frequency for phones connected to the PHONE ports.
0: The ring frequency is determined by the country setting (SET PHONE COUNTRY).
20, 25, 40, 50: Ringer frequency in hertz.
ENABLE PHONE CALLERID
DISABLE PHONE CALLERID
Valid context: General
Enables or disables caller ID for connected phones (POTS). When enabled, telephones with Call Display will
display incoming call information.