Eicon Networks DIVA LAN ISDN - Manual (Page 145)

Chapter Ten: Other Configuration Tools DTMF interface 145
DTMF interface
The DIVA LAN ISDN Modem enables you to set certain parameters using a standard touch-tone telephone.
Prerequisites
• touch-tone analog phone
Local access
• Phone must be plugged into PHONE port 2.
• ISDN line must not be connected.
Remote access
• Not available.
How it works
Plug an analog phone into PHONE port 2.
• Each command starts and ends with a #.
• A short beep indicates that the command you entered was accepted.
• Continuous beeping indicates that the command you entered was rejected. Enter # to start a new command
and end the beeping.
Commands
The following commands are available.
Set primary ISDN telephone number
#TN1 ISDN number # (#861ISDN number #)
Example: #8614078#
Set second ISDN telephone number
#TN2 ISDN number # (#862 ISDN number #)
Example: #8624079#
Set ISDN switch type
• #STA# (#782#) AT&T 5ESS
• #STP# (#787#) AT&T 5ESS Point-to-Point
• #STN# (#786#) NI-1
• #STD# (#783#) Detect Switch Type Automatically
Save configuration and reset
#SA# (#72#)
Reset to factory defaults
#RF# (#73#)
Set LAN IP address
#IPxxx*xxx*xxx*xxx# (#47xxx*xxx*xxx*xxx#)
Example: #47192*168*4*1#.
Set LAN IP subnet mask
#SMxxx*xxx*xxx*xxx# (#76xxx*xxx*xxx*xxx#)
Example: #76255*255*255*0#.