Troubleshooting guide, Power-related problems – Canon EOS Rebel SL3 DSLR Camera with 18-55mm Lens (Black) User Manual
Page 465
465
Troubleshooting Guide
If a problem occurs with the camera, first consult this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem, contact
your dealer or nearest Canon Service Center.
Power-Related Problems
The battery does not recharge.
z
Do not use any battery other than genuine Canon Battery Pack LP-E17.
The battery charger’s lamp blinks.
z
If (1) the battery charger or battery has a problem or (2) communication
with the battery failed (with a non-Canon battery pack), the protection
circuit will stop charging, and the charge lamp will blink in orange.
In the case of (1), unplug the charger’s power plug from the power
outlet. Detach and reattach the battery to the charger. Wait two or
three minutes, then reconnect the power plug to the power outlet. If the
problem persists, contact your dealer or nearest Canon Service Center.
The camera is not activated even when the power switch is set to
<
1
>.
z
Make sure the battery is installed properly in the camera (
z
Make sure the card slot/battery compartment cover is closed (
z
z
Press the <
U
> button (
The access lamp still blinks even when the power switch is
<
2
>.
z
If the power is turned off while an image is being recorded to the
card, the access lamp will remain on or continue to blink for a few
seconds. When the image recording is complete, the power will turn off
automatically.