Extron electronic VGA MATRIX SWITCHERS MVX PLUS 128 - Manual (Page 63)

3-41 MVX Plus 128 VGA Matrix Switchers • Operation
PRELIMINAR
Y
Rear Panel Controls
The rear panel has a Reset button that initiates four levels of matrix switcher resets.
Press and hold the button while the switcher is running or while you apply power
to the switcher for different reset levels.
Performing soft system resets
The switchers have three soft resets available that restore various tiers of switcher
settings to their default settings.
• Events (mode 3) reset — This function toggles the monitoring of events on
or off (if events monitoring was on, this function turns it off; if it was off, it is
turned on).
• IP settings (mode 4) reset — The IP settings reset performs the following
functions:
Enables ARP program capability.
Resets the IP address to the factory default (192.168.254.254).
Resets the subnet mask to the factory default (255.255.0.0).
Resets the gateway address to its factory default (0.0.0.0).
Turns DHCP off.
Turns events off.
N IP settings reset does not replace any user-installed fi rmware.
• Absolute (mode 5) reset — Absolute reset restores the switcher to the default
factory conditions. This function is identical to the Esc ZQQQ SIS command
(see chapter 4, Programmer’s Guide).