Extron electronic VGA MATRIX SWITCHERS MVX PLUS 128 - Manual (Page 44)

Operation, cont’d
MVX Plus 128 VGA Matrix Switchers • Operation 3-22
PRELIMINAR
Y
2 . Press and hold the RGBHV button for approximately 2 seconds (fi gure 3-35).
RGBHV RGBHV
Press and hold the RGBHV button until it blinks.
2 seconds
= Blinking button
Figure 3-35 — Select RGB Delay mode
3 . Press and release the output 17 button (fi gure 3-36).
3 1 2 3
INPUTS
1 2 3 4 5 6 9 10 7 8 1
Press and release the
Output 1 button.
The button lights green.
The Input 1 through Input 10 buttons display the selected output's RGB
delay. Each lit input button indicates half a second of delay.
In this example, the green input buttons display 3.5 seconds of RGB delay.
3.5 3.0 2.5 2.0 1.5 1.0 0.5
= Unlit button = Lit button
Figure 3-36 — Select an output
4 . Press and release the Esc ( > ) button once (fi gure 3-37) to increase the RGB
delay by a half second.
Press and release the Esc ( > ) button twice more to increase the RGB delay by a
whole second. Note the input button indication changes that occur each time
the Esc (
> ) button is pressed and released.
Figure 3-37 show the result of pressing the Esc ( > ) button a total of three
times.
ESC ESC ESC
INPUTS
1 2 3 4 5 6 9 10 7 8 1
3.5 4.0 4.5 5.0 3.0 2.5 2.0 1.5 1.0 0.5
Press the Esc button to increase the RGB interval that is applied to switches to
the selected output by a half second per button push.
= Unlit button = Lit button
The Input 1 through Input 10 buttons display the selected output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the green input buttons display 5.0 seconds of RGB interval.
Figure 3-37 — Adjust the RGB delay interval