Extron electronic VGA MATRIX SWITCHERS MVX PLUS 128 - Manual (Page 62)

Operation, cont’d
MVX Plus 128 VGA Matrix Switchers • Operation 3-40
PRELIMINAR
Y
Selecting the RS-232/RS-422 protocol and baud rate
The switcher can support either RS-232 or RS-422 serial communication protocol,
and operate at 9600, 19200, 38400, and 115200 baud rates. The settings of these
variables can be viewed and changed from the front panel.
View and confi gure the switcher’s serial communications settings as follows:
1 . To enter Serial Port Confi guration mode, simultaneously press and hold all
Control buttons (Enter, Preset, View, and Esc) (fi gure 3-67).
C O N T R O L
PRESET ENTER
I / O
RGBHV AUDIO
C O N T R O L
PRESET ENTER ESC VIEW ESC VIEW
2 seconds
All Control buttons light with one flashing.
Both I/O buttons light with one flashing.
The flashing Control button indicates the baud rate as follows:
Enter — 9600
Preset — 19200
View — 38400 Esc — 115200
The flashing I/O button indicates the protocol as follows:
RGBHV — RS-232
Audio — RS-422/RS-485
In this example, the port is set to RS-232 at 9600 baud.
Press and hold the Enter, Preset, View, and Esc buttons.
= Blinking button
Figure 3-67 — RS-232/RS-422 and baud rate display
2 . Release the Control buttons.
3 . To change a value , press and release the button that relates to the desired
value (fi gure 3-68).
C O N T R O L
PRESET ENTER
I / O
RGBHV AUDIO ESC VIEW
Press and release the button(s) to configure the port as
follows:
Baud rate:
Enter — 9600
Preset — 19200
View — 38400 Esc — 115200
Serial protocol:
RGBHV — RS-232
Audio — RS-422/RS-485
The selected buttons blink and the others remain lit.
In this example, the port is set to RS-422 at 38400 baud.
= Blinking button
Figure 3-68 — RS-232/RS-422 and baud rate selection
4 . Press and release an input or output button to exit the Serial Port Confi guration
mode (fi gure 3-69).
C O N T R O L
PRESET ENTER
I / O
RGBHV AUDIO ESC VIEW 5
All Control and I/O buttons return to unlit or background illumination.
Press and release an
input or output button.
Figure 3-69 — Exit Serial Port Confi guration mode