Extron electronic VGA MATRIX SWITCHERS MVX PLUS 128 - Manual (Page 100)

Matrix Software, cont’d
MVX Plus 128 VGA Matrix Switchers • Matrix Software 5-12
PRELIMINAR
Y
E-mail Addressee fi elds
The eight E-mail Addressee fi elds permit the administrator to identify the e-mail
addresses of the personnel to whom the MVX Plus 128 switcher e-mails notifi cation
of its failure and repair status. Figure 5-6 shows a typical e-mail from the switcher.
Miles Standish
From: Crosspoint/MAV/[email protected]
Sent:
Tuesday, November 15, 2005 10:05 AM
To: Miles Standish
Subject: Crosspoint/MAV/Matrix-FF-FF-09 - Input #10 Signal Available
Tue, 15 Nov 2005 10:05:07
Unit Name = Crosspoint/MAV/Matrix-FF-FF-09
Unit IP Address = 192-168-254-254
Figure 5-6 — Typical MVX Plus 128 e-mail
The radio buttons and check boxes associated with each address fi eld permit the
administrator to specify specifi c e-mail requirements for each recipient.
Edit these fi elds and controls as follows:
1 . Click in the desired E-mail Addressee fi eld. The graphic cursor becomes a text
cursor.
2 . Edit the e-mail address as desired. Standard e-mail address conventions
(for example: nnnnn@xxx.com) apply.
3 . Press the Tab key on the keyboard or click in another fi eld to exit the e-mail
addressee fi eld.
4 . In the square check boxes associated with each addressee, select the options
about which the addressee is to be e-mailed: missing input(s), fans, and/or
power supply. In the fl oating box that contains the input numbers, select the
inputs that need monitoring.
5 . In the round radio buttons associated with each addressee, select whether the
addressee is to be e-mailed of failures, fi xes, both, or not be notifi ed.
The None radio button is useful for temporarily removing personnel from the
e-mail list when they are unavailable, such as on travel or vacation.
6 . If desired, click on the Send test E-mail button to test the e-mail function.
7 . Click the Take button to make the e-mail address changes take affect.