beautypg.com

Preliminar y, Audio connections – Extron electronic VGA MATRIX SWITCHERS MVX PLUS 128 User Manual

Page 19

background image

2-3

MVX Plus 128 VGA Matrix Switchers • Installation

PRELIMINAR

Y

Audio connections

By default, the audio ties follow the video ties. Audio breakaway, which can be
activated via the front panel or under Ethernet or RS-232/RS-422 control, allows
you to select from any one of the audio input sources and route it separately from
its corresponding video source. See chapter 3, Operation, chapter 4, Programmer’s
Guide
, chapter 5, Switcher Software, and chapter 6, HTML Operation for details.

c

Connections for balanced and unbalanced audio inputs — Each input has

a 3.5 mm, 5-pole captive screw connector for balanced or unbalanced stereo
audio input. Connectors are included with each switcher, but you must
supply the audio cable. See fi gure 2-2 to wire a connector for the appropriate
input type and impedance level. High impedance is generally over 800 ohms.

Unbalanced Input

Tip

Sleeve

Tip

Sleeve

Balanced Input

Tip

Ring

Sleeve (s)

Tip

Ring

Tip

Ring

Sleeve (s)

Tip

Ring

Balanced Input

(high impedance)

(high impedance)

(600 ohms)

600 ohms

600 ohms

Figure 2-2 — Captive screw connector wiring for audio inputs

C

The captive screw audio connector can easily be inadvertently plugged
partially into one receptacle and partially into an adjacent receptacle. This
misconnection could damage the audio output circuits. Ensure that the
connector is plugged fully and only into the desired input or output.

N See

fi gure 2-3 to identify the tip, ring, and sleeve when you are making

connections for the switcher from existing audio cables. A mono audio connector
consists of the tip and sleeve. A stereo audio connector consists of the tip, ring
and sleeve. The ring, tip, and sleeve wires are also shown on the captive screw
audio connector diagrams, fi gure 2-2 and fi gure 2-4.

Tip (+)

Sleeve ( )

Sleeve ( )

Ring (-)

Tip (+)

RCA Connector

3.5 mm Stereo Plug Connector

(balanced)

Figure 2-3 — Typical audio connectors

The audio level for each input can be individually set via the front panel or
Ethernet or RS-232/RS-422 control to ensure that the level on the output does
not vary from input to input. See chapter 3, Operation; chapter 4, Programmer’s
Guide
; chapter 5, Switcher Software; and chapter 6, HTML Operation for details.