NEC 40,000-Lumen 4K Laser Installation Projector - Manual (Page 73)

56
3. Convenient Features
TIP:
To call up the stored values from [LENS MEMORY]:
1. From the menu, select [ADJUST]
→ [LENS MEMORY] → [MOVE] and press the ENTER button.
The confirmation screen will be displayed.
2. Press the ◀ button to select and [YES] and press the ENTER button.
During projection, if the adjusted values for an input signal have been saved, the lens will shift. If not, the lens will
shift according to the adjusted values stored in the selected [REF. LENS MEMORY] [PROFILE] number.
To automatically apply the stored values at the time of source selection:
1. From the menu, select [SETUP]
→ [REF. LENS MEMORY] → [LOAD BY SIGNAL] and press the ENTER button.
2. Press the ▼ button to select and [ON] and press the ENTER button.
This will move the lens automatically to the position at the time of source selection according to the adjusted
values.
NOTE: The Lens Memory function may not produce a completely aligned image (due to tolerances in the lenses) using the adjusted
values stored in the projector. After calling up and applying the stored values from the Lens Memory function, finely adjust the lens
shift, zoom and focus to produce the best possible image.