NEC 40,000-Lumen 4K Laser Installation Projector - Manual (Page 103)

86
5. Using On-Screen Menu
[COLOR CORRECTION]
Corrects the color for all signals.
Adjusts the tone for the colors red, green, blue, yellow, magenta and cyan.
RED HUE + Direction Magenta direction
− Direction Yellow direction
SATURATION + Direction Vivid
− Direction Weak
GREEN HUE + Direction Yellow direction
− Direction Cyan direction
SATURATION + Direction Vivid
− Direction Weak
BLUE HUE + Direction Cyan direction
− Direction Magenta direction
SATURATION + Direction Vivid
− Direction Weak
YELLOW HUE + Direction Red direction
− Direction Green direction
SATURATION + Direction Vivid
− Direction Weak
MAGENTA HUE + Direction Blue direction
− Direction Red direction
SATURATION + Direction Vivid
− Direction Weak
CYAN HUE + Direction Green direction
− Direction Blue direction
SATURATION + Direction Vivid
− Direction Weak
[COLOR SETTING]
The color range (color reproduction range) of the projected image can be adjusted by inputting the red, green, blue
and white color coordinates of the projection light using a chroma meter that can measure color coordinates.
The specified color (target color: [TCGD]) can be reproduced by measuring the value of the native color (color without
color compensation) and registering it in [MCGD].
Leave the light source on for at least 15 minutes before performing the [COLOR SETTING] in order to stabilize the
brightness.
First set the [MCGD] color coordinates using the chroma meter, then set the color coordinates you want to display
as the [TCGD]s.
We recommend using a spectral radiance meter with a narrow wavelength range that is capable of measuring the
color range.
NOTE:
• The color setting cannot be performed when [HIGH-BRIGHT] has been selected for [DETAIL SETTINGS].
[SETTING]
Enables/disables the color setting.
When enabled, [MCGD] and [TCGD] can be set.
[MCGD]
Enter the color coordinates of the projected image.
REFERENCE ........... Read the setting values of the RED/GREEN/BLUE/WHITE color coordinates.
STANDARD: This loads the factory settings. The red, green, blue and white color coordinates cannot be input.
USER1/USER2: Two user settings can be registered here.
RED/GREEN/BLUE/WHITE
.............................. Set the color coordinates.