NEC 40,000-Lumen 4K Laser Installation Projector User Manual
Page 68
51
3. Convenient Features
Handling of the Address for Operation via a Browser
Regarding the actual address that is entered for the address or entered to the URL column when operation of the
projector is via a browser, the host name can be used as it is when the host name corresponding to the IP address
of the projector has been registered to the domain name server by a network administrator, or the host name cor-
responding to the IP address of the projector has been set in the “HOSTS” file of the computer being used.
Example 1: When the host name of the projector has been set to “pj.nec.co.jp”, access is gained to the network
setting by specifying
http://pj.nec.co.jp/index.html
for the address or the entry column of the URL.
Example 2: When the IP address of the projector is “192.168.73.1”, access is gained to the network setting by
specifying
http://192.168.73.1/index.html
for the address or the entry column of the URL.
⓮
Storing Changes for Lens Shift, Zoom, and Focus [LENS
MEMORY]
This function serves to store the adjusted values when using the LENS SHIFT, ZOOM and FOCUS buttons of the pro-
jector. Adjusted values can be applied to the signal you selected. This will eliminate the need to adjust lens shift, focus,
and zoom at the time of source selection. There are two ways to save adjusted values for lens shift, zoom, and focus.
Function name
Description
page
REF. LENS MEMORY
Adjusted values common to all input signals. At the time of installation,
two kinds of adjusted values can be stored.
If no adjusted values have been saved to [LENS MEMORY], the lens
will apply [REF.LENS MEMORY] adjusted values.
→
LENS MEMORY
Adjusted values for each input signal.
Use the adjusted values for the signal with a different aspect ratio or
resolution. The adjusted values can be applied at the time of source
selection.
→
NOTE:
• Be sure to carry out [LENS CALIBRATION] after installing the lens unit L4K-11ZM/L4K-15ZM/L4K-20ZM.
If you need to replace the lens unit, contact your distributor and have them do it for you.