NEC 40,000-Lumen 4K Laser Installation Projector - Manual (Page 106)

89
5. Using On-Screen Menu
[IMAGE OPTIONS]
Adjusting Horizontal/Vertical Position [HORIZONTAL/VERTICAL]
Adjusts the image location horizontally and vertically.
NOTE:
• The adjustments for [HORIZONTAL] and [VERTICAL] will be stored in memory for the current signal. The next time you project
the signal with the same resolution, horizontal and vertical frequency, its adjustments will be called up and applied.
To delete adjustments stored in memory, from the menu, you select [SETUP] → [RESET] → [CURRENT SIGNAL] and reset the
adjustments.
• In the following cases, [HORIZONTAL] and [VERTICAL] cannot be adjusted.
- When the input signal is an interlace signal
- When [SDI LINK] is set to [QUAD] or [QUAD (2SI)]
- When [DP LINK] is set to [DUAL]