NEC 40,000-Lumen 4K Laser Installation Projector - Manual (Page 115)

98
5. Using On-Screen Menu
To call up the adjusted values from [LENS MEMORY]:
1. From the menu, select [ADJUST]
→ [LENS MEMORY] → [MOVE] and press the ENTER button.
The confirmation screen will be displayed.
2. Press the ◀ button to select and [YES] and press the ENTER button.
To automatically apply the adjusted values at the time of source selection:
1. From the menu, select [ADJUST]
→ [LENS MEMORY] → [LOAD BY SIGNAL] and press the ENTER button.
2. Press the ▼ button to select and [ON] and press the ENTER button.
This will move the lens automatically to the position at the time of source selection according to the adjusted
values.
NOTE:
• The Lens Memory function may not produce a completely aligned image (due to tolerances in the lenses) using the adjusted
values stored in the projector. After calling up and applying the adjusted values from the Lens Memory function, finely adjust the
lens shift, zoom and focus to produce the best possible image.