NEC 40,000-Lumen 4K Laser Installation Projector - Manual (Page 34)

17
2. Projecting an Image (Basic Operation)
❷
Connecting the Power Cable
Consult your distributor for installing the power cable to the projector.
If AC power is supplied to the projector and light with one power cable (C1 connection), it is not necessary to connect
the cable to the projector power supply.
The power cable is not included with the projector. Use a power cable that meets the standards and power supply volt-
age of the country where you are using the projector. Ask your distributor for the power cable to select and purchase.
WARNING
• Consult your distributor for installing the power cable to the projector. DO NOT install the power cable by yourself.
Doing so may cause a fire or electric shock.
• Before connecting the power cables, check that the projector power switch and light power switch of the projector
is turned off. Implement the connection with AC power shut off.
• Be sure to ground the equipment to ensure safety. Use a power cable that meets the standards and power sup-
ply voltage of the country where you are using the projector, and always connect the equipment to the ground.
If the ground is not connected, it may cause electrical shocks.
• When connecting the power cable plugs to the AC IN and the electrical outlet, securely insert the plugs all the
way in.
For C2 connection, be sure to install the power cable stopper.
If the connection between the power cable plug and the electrical outlet is loose, the plug area may generate
heat, causing burns and accidents.
1. Connect the AC power supply cable.
Connect the AC power supply cable to the projector.
To wall outlet
AC input
2. Connect the power plug to the electrical outlet.
This completes the connection of the AC power supply
cable.