NEC 40,000-Lumen 4K Laser Installation Projector - Manual (Page 149)

132
5. Using On-Screen Menu
[POWER OPTIONS]
Enabling Direct Power On [DIRECT POWER ON]
Turns the projector on automatically when the power cable is inserted into an active power outlet. This eliminates the
need to always use the POWER button on the remote control or projector cabinet.
Turning On the Projector by Detecting Input Signal [AUTO POWER ON SELECT]
Under the state of standby, the projector automatically detects and projects synchronizing signal input from the se-
lected terminals by this function.
OFF ........................ AUTO POWER ON SELECT function becomes inactive.
HDMI1, HDMI2, DisplayPort1, DisplayPort2, HDBaseT, SDI1, SDI2, SDI3, SDI4, SLOT
.............................. When the projector detects the computer signal input from the selected terminal, automatically it will be
turned ON and will project the computer screen.
NOTE:
• If you want to activate this AUTO POWER ON SELECT function after powering OFF the projector, interrupt signal from input
terminals or pull out the computer cable from the projector and wait for over 3 seconds and then input signal from the selected
terminal.