GeoVision GV-R1352 Card Reader (13.56 MHz) - Manual (Page 39)

30
2.7 Configure GID
The reader reads the UID (Unique Identifier) on access control cards or key fobs by default.
Using GV-R/RK/DFR Setup AP , you can set the reader to read GID (GeoVision Identifier) on
GV-AS ID Cards / Key Fobs instead.
Note:
1. For how to install the Config AP, see 2.4 Install GV-R/RK/DFR Setup AP. For how to
identify the COM port of the reader, see Note 1, 2.5.1 Define the ID and Set the
Reader to Slave .
2. GID format is only supported by GV-RK1352 / GV-R1352 / GV-DFR1352 (Rev. B)
V1.2 or later.
3. GID is only supported by GeoVision access cards and key fobs.
1. Run GV-R/RK/DFR Setup AP .
2. Select the COM port that is connected to the reader and click Open COM . The red
square next to the COM port box should change to blue to indicate the COM port is
correct.
3. To set the reader to read GID, select Only Read GID .