GeoVision GV-R1352 Card Reader (13.56 MHz) - Manual (Page 38)

GV-RK1352 / R1352 / DFR1352
29
2
After wiring the beeper, go to GV-ASManager and select the alarm conditions that will
activate it. To configure the alarm conditions in GV-ASManager, right-click the controller in
the device list, select Settings , and then the Door / Gate tab.
2.6.3 Set the Beeper and LED for Each Door/Gate
After connecting the wires for the beeper or LED, specify the conditions to activate the
beeper or LED on the GV-AS210 / 2110 / 2120 / 410 / 4110 / 810 / 8110 Web interface.
1. On the controller ’s Web interface, click Output Setting . This page appears.
a
b
2. Find the output # wired to the beeper or LED and specify up to 2 alarm conditions to
activate the beeper or LED.
a. Output Type: Select Normal , Toggle or Pulse . If you select Pulse, specify the
duration in seconds for the beeper or LED to be activated.
b. Output Conditions: Select the door and the alarm condition to activate the beeper
or LED. Up to 2 sets of output conditions can be set.
3. Click Submit .