GeoVision GV-R1352 Card Reader (13.56 MHz) - Manual (Page 16)

GV-Reader1251 / 1352 V2 and GV-SR1251
7
1
Defining Readers on GV-AS Controller Web Interface
After configuring the switch settings of GV-Reader1251 / 1352 V2 or defining the ID number
of GV-SR1251 using GV-R/RK/DFR Setup AP, you need to specify which door each reader
controls on the Web interface of GV-AS Controller.
1. On the controller
’s Web interface, select
Extended Reader . This page appears.
2. If the readers are connected using RS-485, select the RS485 checkbox in front of the ID
number. The ID number must match the ID you configured using SW5 – SW7 (for GV-
Reader1251 / 1352 V2) or GV-R/RK/DFR Setup AP (for GV-SR1251).
3. Leave the serial number field blank.
4. Select a door/gate for the reader under Function . Click Submit .