Appendix b - scpi command/query definitions, B.1 introduction, Table b-1. scpi subsystem command/query index – KEPCO KLP Series (older -1200 models) Operator Manual User Manual
Page 87: Endix b
![background image](https://www.manualsdir.com/files/860634/content/doc087.png)
KLP 073008
B-1
APPENDIX B - SCPI COMMAND/QUERY DEFINITIONS
B.1
INTRODUCTION
This appendix defines the SCPI subsystem commands and queries used with the KLP Power
Supply. Subsystem commands are defined in PAR. B.3 through B.92, arranged Alphabetically
in groups as they appear in the tree diagram, Figure 3-3. Table B-1 provides a quick reference
of all SCPI subsystem commands and queries used in the Interface Card.
TABLE B-1. SCPI SUBSYSTEM COMMAND/QUERY INDEX
COMMAND
PAR.
COMMAND
PAR.
ABORt
[SOUR:]VOLT:MODE, ?
CAL
[SOUR:]VOLT:PROT:LEV, ?
DISP:TEXT?
[SOUR:]VOLT[:LEV]:TRIG[:AMP]?
INIT[:IMM]
STAT:OPER:COND?
INIT:CONT, ?
STAT:OPER:ENAB, ?
[SOUR:]LIST:CLE
STAT:OPER[:EVENT]?
[SOUR:]LIST:CONT, ?
STAT:PRES
[SOUR:]LIST:COUN, ?
STAT:QUES[:EVENT]?
[SOUR:]LIST:COUN:SKIP, ?
STAT:QUES:COND?
[SOUR:]LIST:CURR, ?
STAT:QUES:ENAB, ?
[SOUR:]LIST:CURR:POIN?
SYST:COMM:GPIB:ADDR, ?
[SOUR:]LIST:DIR, ?
SYST:COMM:SER:BAUD, ?
[SOUR:]LIST:DWEL, ?
SYST:COMM:SER:ECHO, ?
[SOUR:]LIST:DWEL:POIN?
SYST:COMM:SER:ENAB, ?
[SOUR:]LIST:QUER, ?
SYST:COMM:SER:PACE, ?
[SOUR:]LIST:VOLT, ?
SYST:COMM:SER:PROM, ?
[SOUR:]LIST:VOLT:POIN?
SYST:ERR?
MEAS:CURR?
SYST:ERR:CODE?
MEAS:VOLT?
SYST:ERR:CODE:ALL?
OUTP[:STAT], ?
SYST:KLOCK, ?
OUTP[:STAT]:PROT:DEL, ?
SYST:LANG, ?
[SOUR:]CURR[:LEV][:IMM][:AMP], ?
SYST:PASS:CEN
[SOUR:]CURR:LIM:HIGH, ?
SYST:PASS:CDIS
[SOUR:]CURR:MODE, ?
SYST:PASS:NEW
[SOUR:]CURR:PROT[:LEV], ?
SYST:PASS:STAT?
[SOUR:]CURR[:LEV]:TRIG[:AMP], ?
SYST:SEC
[SOUR:]FUNC:MODE, ?
SYST:SET, ?
[SOUR:]VOLT[:LEV][:IMM][:AMP], ?
SYST:VERS?
[SOUR:]VOLT:LIM:HIGH, ?
TRIG:SOUR