KEPCO KLP Series (older -1200 models) Operator Manual - Manual (Page 19)

KLP 073008
1-5
PROGRAMMING CHARACTERISTICS - ANALOG
Analog remote control selection Activate with jumper at analog program-
ming connector
Recognized during power up.
isolation Safety Extra Low Voltage (SELV) referenced to chassis
Programming by voltage voltage 0-10V Programmable
current minimal value-10V
Programming by resistance voltage 0-10K ohms Programmable
current 0-10K ohms
Readback 0-10V proportional signal Proportional to analog control volt-
age/resistance
Remote inhibit TTL compatible
Composite status flag Isolated form C contacts Programmable functions (PAR. 2.7.10)
Programming time 20 milliseconds 10% to 90% E
out
PROGRAMMING CHARACTERISTICS - DIGITAL
Digital remote control isolation Safety Extra Low Voltage (SELV) referenced to chassis
format compatible with SCPI protocols W95, W98 and NT operating systems
Programming resolution 0.024% of Emax and Ilim
Programming accuracy 0.05% of Emax and Ilim
Readback resolution 0.024% of Emax and Ilim
Readback accuracy 0.1% of Emax and Ilim
Status reporting OVP, OCP, OTP, output lead fault
(OLF), fan failure, power loss See PAR. 1.4.4 and 1.4.9
NOTES:
(1) Requires the a-c input to be recycled for restart
(2) OVP and OCP limit adjustment is disabled in Remote Analog Mode
TABLE 1-2. KLP SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION CONDITION