KEPCO KLP Series (older -1200 models) Operator Manual - Manual (Page 25)

KLP 073008
1-11/1-12 Blank)
TABLE 1-4. ACCESSORIES
ITEM FUNCTION
KEPCO
PART NUMBER
Line Cord Set (125V/20A) 2.5m long cord set, provides for source power
connection. Mates with NEMA 5-20R receptacle
(see adjacent figure). Supports rated load power
over mains voltage range of 90-136V a-c. NEMA 5-20R 118-0776
Line Cord Set (125V/15A) 2.5m long cord set, provides for source power
connection. Mates with NEMA 5-15R receptacle
(see adjacent figure). Supports restricted load
power over mains voltage range of 90-136V a-c
(contact Kepco Sales Engineering for details). NEMA 5-15R 118-1136
Line Cord Set (250V/15A) 2.5m long cord set, provides for source power
connection. Mates with NEMA 6-15R receptacle
(see adjacent figure). Supports rated load power
over mains voltage range of 180-265V a-c. NEMA 6-15R 118-1137
IEEE 488 (GPIB) Cable, 1m long Connect KLP Power Supply to GPIB bus. SNC 488-1
IEEE 488 (GPIB) Cable, 2m long Connect KLP Power Supply to GPIB bus. SNC 488-2
IEEE 488 (GPIB) Cable, 4m long Connect KLP Power Supply to GPIB bus. SNC 488-4
Chassis Slide (2) Allows rack-mounted units to slide in and out. 108-0239
(Jonathan
375-QD Series)
Analog Connector Backshell Locks analog port mating connector to KLP via jackscrews. 108-0204
Loop Back Test Connector Used for verification of RS 232 operation. 195-0112
Null Modem Cable, DB9F to
DB9F, 10 ft long Connect RS 232 port with controlling computer 118-1176
Support bracket, rear Provides extra support to rear of rack-mounted unit if needed. Two
brackets required per unit. Each bracket requires 2 screws and 2
washers. See Figure 1-3, sheet 1, Detail “A” for requirements. 128-2306
TABLE 1-5. SAFETY SYMBOLS
SYMBOL MEANING
CAUTION: RISK OF ELECTRIC SHOCK.
CAUTION: REFER TO REFERENCED PROCEDURE.
WARNING INDICATES THE POSSIBILITY OF BODILY INJURY OR DEATH.
CAUTION INDICATES THE POSSIBILITY OF EQUIPMENT DAMAGE.
!