KEPCO KLP Series (older -1200 models) Operator Manual - Manual (Page 18)

1-4
KLP 073008
GENERAL (ENVIRONMENTAL) SPECIFICATIONS
Temperature operating -20 to +50 deg C Rated load. Derate at 25W per °C
between 50 and 70°C.
storage -40 to +85 deg C
Cooling 3 internal d-c fans exhaust to the rear
Humidity 0 to 95% RH non condensing
Shock 20g, 11msec +/- 50% half sine non operating
Vibration 5 -10 Hz 10mm double amplitude 3-axes, non-operating
10-55 Hz 2g 3-axes, non-operating
Altitude sea level to 10000 ft. 0-3,000 ft: 100%, linear derating to
70% of power at 10,000ft.
PHYSICAL CHARACTERISTICS
Dimensions English 1.75'H x 19"W x 17.5"D depth excluding connectors and termi-
nal blocks (See Figure 1-3.)
metric 44.45 x 482.6 x 443.7 mm
Weight English 15 lbs
metric 6.82kg
Source power connector IEC 320-C19 appliance inlet 250 Va-c, 16A (VDE);
125V a-c, 20A (UL)
Load connections 8-36V models Nickel plated copper busbars Provision for safety covers
75-600V models Shocksafe Euroblock
Analog programming port. 15 pin D-sub
Digital programming port primary Standard GPIB connector IEEE 488.2 (GPIB)
secondary 9 pin D-sub RS 232
Direct output control 5 position low profile Euroblocks
PROGRAMMING CHARACTERISTICS - LOCAL
Local control rotary encoders panel mounted
Local control resolution Coarse ~100 LSB/step depress control for Fine resolution
Fine 1 LSB/step
Setting range 0-100% of rating KLP will decrement limit to maintain
1200 W maximum
Power up settings voltage defaults to zero DIP switch 3 set to off. (If DIP switch 3
set to ON, power up voltage and cur-
rent set to last value set prior to power
down.)
current defaults to minimal value
Protection Limits
(2)
Emax 20-120% Programmable; accessed via front
panel protect switch or IEE 488.2 bus
command.
Imax 60-120%
NOTES:
(1) Requires the a-c input to be recycled for restart
(2) OVP and OCP limit adjustment is disabled in Remote Analog Mode
TABLE 1-2. KLP SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION CONDITION