KEPCO KLP Series (older -1200 models) Operator Manual - Manual (Page 16)

1-2
KLP 073008
FIGURE 1-2. KLP OPERATING REGIONS
TABLE 1-1. MODEL PARAMETERS
Model number
Rated
Voltage
Range
(1)
Maximum
current for
rated voltage
Minimum
programmable
current
Rated
Current
Range
(1)
Maximum
voltage for
rated current
Ripple and noise
Efficiency
@115 Va-c
rms p-p
(2)
KLP 20-120-1200
(3)
0-20V 60A@20V 1.6A 0-120A 10V@120A 10 mV 75 mV 82%
KLP 36-60-1200
(3)
0-36V 33.3A@36V 0.8A 0-60A 20V@60A 10 mV 125 mV 83%
KLP 75-33-1200 0-75V 16A@75V 0.4A 0-33.3A [email protected] 10 mV 125 mV 84%
KLP 150-16-1200 0-150V 8A@150V 0.2A 0-16A 75V@16A 10 mV 125 mV 86%
KLP 300-8-1200 0-300V 4A@300V 0.1A 0-8A 150V@8A 20 mV 300 mV 87%
KLP 600-4-1200
(3)
0-600V 2A@600V 0.05A 0-4A 300V@4A tbd tbd 88%
(1) The maximum current and voltage are constrained by the 1200 watt power limitation, see Figure 1-2.
(2) Bandwidth: 20MHz; low frequency ripple may be higher at loads less than 30 Watts..
(3) Not all models available at this time. Please contact factory for additional information.