KEPCO KLP Series (older -1200 models) Operator Manual - Manual (Page 28)

2-2
KLP-HV 073008
FIGURE 2-2. KLP SERIES, REAR PANEL SWITCH AND CONNECTORS
7 DC AMPERES
display
Four-digit LED display that shows current settings:
a. Shows actual output current (PAR.3.2.6).
b. Shows current set point or overcurrent limit when function selected (PAR. 3.2.6.2).
c. Shows GPIB address (PAR. 3.2.8), baud rate (PAR. 3.2.9).
d. Shows password (PAR. 3.2.5 and PAR. 4.3).
8 CURRENT
control/
momentary switch
Multifunction rotary encoder. Rotate to set output current (PAR. 3.2.6) and overcurrent
limit (PAR. 3.2.7). Also used to enter SET mode of current programming (PAR. 3.2.6.2),
change GPIB address (PAR. 3.2.8), change RS232 baud rate (PAR. 3.2.9), enter Vir-
tual Model password (PAR. 3.2.5), and enter calibration password and perform calibra-
tion (PAR. 4.3)
9 DC OUTPUT
indicator
Green LED lights when DC output is enabled. LED is off when output is disabled.
10 DC OUTPUT
on/off switch
Enables or disables the DC Output. When output is disabled, current and voltage are
programmed to minimal value and zero, respectively (PAR. 3.2.3). Also used to accept
front panel inputs.
11 PROTECT
momentary switch
Used to set overvoltage and overcurrent (PAR. 3.2.7) protection limits.
NOTE: Requires a thin tool (e.g., end of paper clip) to press switch.
12 FUNCTION
momentary switch
Used to enter calibration (PAR. 4.3), change GPIB address (PAR. 3.2.8) and change
RS232 baud rate (PAR. 3.2.9) and (for -1200 models) set user-determined limits on
voltage and current (virtual model) (PAR. 3.2.5).
NOTE: Requires a thin tool (e.g., end of paper clip) to press switch.
TABLE 2-1. CONTROLS, AND INDICATORS (CONTINUED)
FIGURE 2-1
INDEX NO.
CONTROL OR
INDICATOR
FUNCTION