KEPCO KLP Series (older -1200 models) Operator Manual - Manual (Page 29)

KLP-HV 073008
2-3
TABLE 2-2. ANALOG I/O SWITCH FUNCTIONS
DIP SWITCH
POSITION
FUNCTION SETTINGS
1
Allows analog programming commands for voltage to be provided
by either variable voltage (PAR. 3.7.3) or resistance (PAR. 3.7.2).
When resistance mode is selected, an internal 1mA current genera-
tor provides the reference for voltage programming. (PAR. 3.7.2) ON: Selects Resistance
OFF: Selects Voltage (factory
default)
2
Allows analog programming commands for current to be provided
by either variable voltage (PAR. 3.7.3) or resistance (PAR. 3.7.2).
When resistance mode is selected, an internal 1mA current genera-
tor provides the reference for current programming. ON: Selects Resistance
OFF: Selects Voltage (factory
default)
3
When enabled (ON), allows retention of the last entered setpoint val-
ues for voltage and current in non-volatile memory for recall at the
next power-up sequence. (see PAR. 3.2.6.3). If not selected (OFF,
default condition), the stored values will be 0 volts, minimum amps.
The switch setting is detected upon unit power-up. ON: Save and recall previous set-
point values upon power-up.
OFF: Power-up set to 0 Volts and
minimum current (factory
default).
4 NOT USED
5
Allows locking of the front panel controls. (see PAR. 3.2.2.1) ON: Local controls locked.
OFF: Local controls enabled (fac-
tory default).
TABLE 2-3. IEEE 488 PORT CONNECTOR (J4) PIN ASSIGNMENTS
CONNECTOR PIN SIGNAL NAME FUNCTION
IEEE 488
PORT
1 D I 01 I/O Line
2 D I 02 I/O Line
3 D I 03 I/O Line
4 D I 04 I/O Line
5 EOI End or Identify
6 DAV Data Valid
7 NRFD Not Ready for Data
8 NDAC Not Data Accepted
9 IFC Interface Clear
10 SRQ Service Request
11 ATN Attention
12 SHIELD Shield
13 D I 05 I/O Line
14 D I 06 I/O Line
15 D I 07 I/O Line
16 D I 08 I/O Line
17 REN Remote Enable
18 GND Ground (signal common)
19 GND Ground (signal common)
20 GND Ground (signal common)
21 GND Ground (signal common)
22 GND Ground (signal common)
23 GND Ground (signal common)
24 LOGIC GND Logic Ground