TA Triumph-Adler 2256 - Manual (Page 56)

3-17
Sending Faxes > FAX Direct Transmission
FAX Direct Transmission
You can directly transmit originals without scanning them into the memory. Scanning of the originals starts after the
connection is made with the receiving system, allowing you to verify that each page of the fax has been properly sent.
Cancelling Direct Transmission
During direct transmission, to cancel communication during transmission, press the [ Stop ] key. The originals that have
been scanned are ejected, and the screen returns to the fax default screen. When originals remain in the document
processor, take them out.
FAX Delayed Transmission
Set a send time. You can use delayed transmission together with the broadcast transmission function, etc.
The method for sending originals to one destination after setting the start time is explained here.
Setting for Direct
transmission
Description
On Starts direct transmission.
Dials the receiving system, and after the communication has started, originals are scanned.
Off Starts memory transmission.
After originals are scanned into memory, the communication starts.
NOTE
In direct transmission, you can designate only one destination for one transmission.
For the procedure for transmitting FAX, refer to Basic transmission procedure on page 3-2 . The destination is dialed
and communication starts before the original is scanned.
NOTE
In some cases, transmission may take place even if the [ Stop ] key.
Item Description
Off Does not use the delayed transmission.
On Uses the delayed transmission.
Start Time Set the time from between 00:00 and 23:59 in one-minute increments.
IMPORTANT
If the current time displayed on the message display is not correct, you cannot send originals correctly at the
preset time. In this case, adjust the time. For details, refer to
Setting Date and Time on page 1-6 .
NOTE
You cannot select direct transmission.
You can set up to 30 destinations for delayed transmission.
When two or more delayed transmissions are set for the same time, the communication will start in the order that the
delayed transmissions have been set.