TA Triumph-Adler 2256 - Manual (Page 116)

9-6
Fax Settings > Default fax settings
TX/RX Restriction
This function allows you to send or receive originals only when communication requirements are met.
For details, refer to Transmission Restriction on page 9-8 .
Select Key Set. (Select Key Settings)
If you register a function to the Left Select key or Right Select key, you can quickly set the function when using fax
functions.
RX Date/Time Reception Date/Time function adds the reception date/time, sender information and number of
pages on the top of each page when the message is printed out. It is useful for confirming the
time of reception if the fax is from a different time zone.
Value : On, Off
For details, refer to Reception Date/Time on page 4-6 .
Remote SW Dial To start fax reception by operation from the connected telephone set, use the following operation.
Value : 00 - 99
For details, refer to Remote Switch Function on page 7-9 .
Duplex Printing When received multiple pages of data are the same width, they can be printed out on both
sides of paper having the same width as the data.
Value : On, Off
NOTE
The optional duplex unit is required.
For details, refer to Duplex Print Output on page 4-6 .
Unknown Number RX When Reception Restriction is set, you can set whether or not reception is allowed from parties
that do not provide notification of their fax number.
Value : Reject, Permit
For details, refer to Transmission Restriction on page 9-8 .
ECM RX Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International Telecommunication Union)
that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and
other conditions.
Value : On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly
longer than when Off is selected.
RX Start Speed Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In that case,
set a lower RX Start Speed.
Value : 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Item Description