TA Triumph-Adler 2256 - Manual (Page 130)

10-2
Troubleshooting > Indicators During Sending/Receiving Operation
Indicators During Sending/Receiving Operation
The [ Processing ] and [ Memory ] indicators show the fax transmission status.
• The [ processing ] indicator blinks during fax transmission and reception.
• The [ Memory ] indicator is lit when there is source data stored in the memory for delayed transmission.
Responding to an Attention Indicator Flashes
If the [ Attention ] indicator is lit up or blinks, check the message display. If error information is not indicated on the
message display, check the following.
Symptom Checkpoints Corrective Actions Reference
Page
Cannot send fax. Is the modular cord connected
correctly? Connect the modular cord correctly. —
Is Permitted FAX No. registered
correctly? Check Permitted FAX No. 9-8
Has a communication error
occurred? Check error codes in the TX/RX Result
Report and Activity Report. If the error
code starts with "U" or "E", perform the
corresponding procedure. 10-5
Is the destination FAX line busy? Send again. —
Does the destination FAX
machine respond? Send again. —
Is there an error other than
above? Contact your Service Representative. —